| 1. | Finite element analysis of the influence of casing eccentric wear rate on collapsing strength
套管偏磨曲率对其抗挤毁强度影响的有限元分析 |
| 2. | The wear rate and friction coefficient of the in - situ composites increased with increasing the applied load
纳米tib2颗粒增强了cu基体的抗磨损性能。 |
| 3. | 05 . 02 wear rate of materials in unlubricated rubbing contact using a thrust washer testing machine , test for
用止推垫圈试验机测定在非润滑摩擦接触中材料的磨损率的试验 |
| 4. | The results of friction and wear test showed that this wearable composite has lower wear rating , but has bigger friction coefficient
通过对材料进行摩擦磨损试验，结果表面该耐磨复合材料的磨损率较小，但摩擦系数偏大。 |
| 5. | Standard test method for wear rate and coefficient of friction of materials in self - lubricated rubbing contact using a thrust washer testing machine
用止推垫圈试验机测定自润滑磨擦接触中材料磨损速率和摩擦系数的标准试验方法 |
| 6. | The space - saving design allows a classification , pre - screening and control screening of coarse and wet products at a reduced wear rate
它能磨损少且节约空间地对物料进行分类粗筛分以及细筛分，适合于洗选处理粗大以及潮湿物料。 |
| 7. | Xf ： media designed for fast metal removal , deburring & surface improvements . moderate wear rate but very efficient due to reduced cycle times
用于快速切削，去毛刺和改善表面质量，尽管有一定的磨损，但由于减少了工作时间，该磨块显的非常高效。 |
| 8. | At the same time , the study shows that adding 30wt cf has little influence on friction coefficient of bismaleimide matrix wearable composite , but it can reduce the wear rating greatly
研究同时表明， 30份碳纤维的加入，对改性双马树脂基耐磨复合材料的摩擦系数影响不大，却大大降低了材料的磨损率。 |
| 9. | Especially , it also registered a lower wear rate of the polymer counterpart compared with ti6a14v alloy . the worn surfaces of the tested samples were observed with a scanning electron microscope , as an effort to analyze the wear mechanisms
Dlc膜的减摩机理与其表面高硬度含氢非晶态碳膜结构和成分有关，磨损形式主要是轻微的磨粒磨损。 |
| 10. | It is showed that by using the phenolic resin and the fiber , the clutch friction materials could be manufactured with good properties such as stable friction coefficient , low wear rate , high fade resistance at 350 , and suitable porosity
结果表明，采用三组份酚醛树脂和混杂纤维可以制备出摩擦性能良好， 350不发生热衰退的离合器摩擦材料，且材料具有合适的孔隙率。 |
